Requisite Audio Engineering L2M MKIII M/S VERSION Manual do Operador descarregar pdf (Página 18)

OUTBOARD POWER SUPPLIES

POWER SUPPLIES

For the L2M MkIII M/S Version, and all Requisite mainframe audio processors, there is a choice

of two different power supplies:

•

OPS-2D solid-state supply (1 to 2 channels)

•

RTS-4A all-tube supply (1 to 4 channels)

Each supply is conﬁgured for the number of channels required for use a speciﬁc mainframe(s).

Depending on the conﬁguration, there will be a cable(s) with a single, multi-pin connector for

B+, Heaters, Meter Lights and phantom power, which brings power to the mainframe unit(s).

POWER ON

This switch is located at the outboard power supply. When ﬁrst connecting the power supply to

an L2M mainframe, please be sure your main power switch is turned off. Once the connector is

seated, carefully thread the ring lock of the cable to the jack on the L2M mainframe. If powering

only one L2M unit, with a supply having extra cables, be sure the unused cable(s) is rolled-up

and fastened to the supply with a cover over the unused end.

POWER CABLE

Each supply has an IEC connector for mains A/C. In the U.S. and Canada, the supply is

shipped with a North America power cable. For other countries a power cable is not supplied

and must be purchased locally.

VOLTAGE SELECT

Each power supply has a VOLTAGE SELECT to allow operation with A/C mains of 120V or

240V.

FUSE

Each power supply has a replaceable FUSE for overcurrent protection. Be sure to use the Slo-

Blo type (1.25”/32mm long) at the rating indicated on the supply for the mains voltage being

used. When going from 120V to 240V be sure to reduce the fuse to 1/2 the AMP value of the

120V fuse. Otherwise, the fuse will be overrated and not offer the same level of protection.

THE L2M MKIII M/S VERSION

R e q u i s i t e A u d i o E n g i n e e r i n g! L2M MkIII

1 2 ... 13 14 15 16 17 18 19

Sem comentários

Requisite Audio Engineering L2M MKIII M/S VERSION Manual do Operador Página 18